Front pockets are approximately 6 inches deep for most seats. They are placed on the forward side of the seat bottom.
For bench seats they extend nearly the full width of the seat bottom. They are divided into sections but priced as one front pocket.
For bucket seats and split seats (60/40, 50/50, and 40/20/40), they are approximately 9 inches wide (inside dimension). There can be a front pocket on either the driver or passenger side, or both. Each pocket is counted separately for pricing
in this case.
Note that any seat with pistol pockets cannot have a front pocket on the same side.
If you order a pocket for only one side of a seat row or only one bucket seat, please specify whether you want it on the
driver or passenger side.
If the front of the seat bottom is too shallow for a 6-inch pocket to be sewn on three sides, we create a hanging pocket which is attached only at the top seam (see image).
Rear pockets are approximately 15 inches deep and are located on the back of the seat. In most cases the pocket is as wide as the seat back.
A rear pocket for a bench seat runs nearly the full width of the seat and is separated into sections. It is priced as one pocket.
To put a pocket on both bucket seats in a seat row, or each side of a split seat (60/40 or 40/20/40), order two rear pockets.
Please note that rear pockets cannot be combined with our Special OPS™ Package.
If you order a pocket for only one side of a seat row, or only one bucket seat, please specify whether you want it on the driver or passenger side.